Wireless digital remote control

Features

Up to 1500 Feet ( 450 m ) of Line-of-Sight Range
Compatible with 6011 6014 6018 Transmitters
Measured Line-of-Sight Range of 1,500 Feet
Quick-Learn Programming, Selectable Supervision
Individual Outputs Per RF Channel and for Alarm, Low
Battery, and Status Trouble Reports (Connects to Base Panel)
7-Segment Channel Display (Decimal Point Indicates RF Activity);
LED Indication for Alarm, Low Battery, and Status
Over one million factory pre-set codes are available and all receivers
"learn" the transmitter ID
OUTPUT OPTIONS
Type: Open collector
Mode: Factory set to normally open; can be globally selected as normally closed by internal jumper
Current Rating: 100 mA maximum per output point Optional Power Relay
Momentary: 4-second momentary closure on alarm
Toggle: Alternate alarm action (toggle on, toggle off)
Latch: Requires manual reset at receiver, or operates as a follower with transmitters
DISPLAY OUTPUT
Channel Display: One 7-segment LED indicator; displays flashing center dash in power on an standby; displays channel ID during alarm condition along with alarm condition LED; automatically clears when alarm output restores; displays "P" and channel ID during programming mode
RF Activity: Indicated by decimal point on 7-segment display; indicates radio receiver activity; flashes with received data
Alarm Condition: Three LED indicators - alarm, low battery, and status; displays conditions with corresponding channel ID

Specifications

Number of Channels: 4-Channels, supervised
Receiver Carrier Frequency: 315 MHz Bandwidth: 400 KHz typical
Receiver Sensitivity: -102 dBm typical at each antenna
Modulation: Type A1D, PPM (pulse position modulation)
Measured Range: 1,500 feet typical, with most standard stationary transmitters
Transmitter Capacity: 32 total with any distribution between channels
(Note: learning multiple transmitters into any channel will defeat device supervision)
Operating Voltage: 10.2 to 14.4 VDC or 12 to 16 VAC
Operating Current: Standby: 30 Ma; Alarm: Up to 120 mA
Operating Temperature: 32° to 140° F (0° to 60° C)
Dimensions: 7.25 in L x 1 in W x 5 in H (185 x 25.4 x 127 mm)
Space Required for Installation: 7.5 in L x 14.0 in H
Antennae: Two, 9-1/2 in wire whip antennae (supplied)
Mounting Hardware: Four #6 x 1 1/4 in wood screws (supplied)

Receiver Operating Parameters:
Status Supervision: Monitored on each channel for hourly status transmissions, reports status exception if no transmissions received within last 8-hour time period; one common status output provided for all channels; 7-segment display indicates channel where violation occurred; exception set and cleared by channel
Enable Options: Status supervision enabled per channel; status enabled by cutting proper jumper per channel; factory default disabled; Note: with status supervision monitoring, it is not recommended to have more than one transmitter learned per channel
Low Battery Supervision: Monitors each transmitter for low battery alarm; reports if any learned transmitter low battery signal received; one common low battery output for all transmitters; 7-segment display indicates channel where low battery occurred; low battery set and cleared by individual transmitters; transmitter that sends low battery report must send a good battery signal to clear low battery condition
Program Mode: Enabled by program jumper; remove to enter program mode
Transmitter Learn: Momentary press and release desired channel learn button; activate transmitter with five seconds to learn it into desired channel
Memory Erase: Hold appropriate channel learn button for more than 10 seconds and release; transmitters learned into that channel will be erased from receiver memory
Memory Interrogation:
Hold appropriate channel learn button for more than five and less than 10 seconds; alarm LED will flash the number of transmitters learned into selected channels