SPECIFICATIONS

Number of Channels: 4-Channels, supervised  Receiver Carrier Frequency: 315 MHz  Bandwidth: 400 KHz typical  Receiver Sensitivity: -102 dBm typical at each antenna  Modulation: Type A1D, PPM (pulse position modulation)  Measured Range: 1,500 feet typical, with most standard  stationary transmitters  Transmitter Capacity: 32 total with any distribution between channels  (Note: learning multiple transmitters into any channel will defeat device supervision)  Receiver Outputs: 8-Channel alarm outputs, one common low battery output, and one common status output  Type: Open collector  Mode: Factory set to normally open; can be globally selected as normally closed by internal jumper  Current Rating: 100 mA maximum per output point

Wiring Diagram Power Relay

CHANGE OUTPUT OPTIONS
 Momentary: 4-second momentary closure on alarm
 Toggle: Alternate alarm action (toggle on, toggle off)
 Latch: Requires manual reset at receiver, or operates as a follower with  transmitters
DISPLAY OUTPUT
 Channel Display: One 7-segment LED indicator; displays flashing center dash in power on an standby; displays channel ID during alarm condition along with alarm condition LED; automatically clears when alarm output restores; displays "P" and channel ID during programming mode
 RF Activity: Indicated by decimal point on 7-segment display; indicates radio receiver activity; flashes with received data
 Alarm Condition: Three LED indicators - alarm, low battery, and status; displays conditions with corresponding channel ID

 Operating Voltage: 10.2 to 14.4 VDC or 12 to 16 VAC
 Operating Current: Standby: 30 Ma; Alarm: Up to 120 mA
 Operating Temperature: 32° to 140° F (0° to 60° C)
 Dimensions: 7.25 in L x 1 in W x 5 in H (185 x 25.4 x 127 mm)
 Space Required for Installation: 7.5 in L x 14.0 in H
 Antennae: Two, 9-1/2 in wire whip antennae (supplied)
 Mounting Hardware: Four #6 x 1 1/4 in wood screws (supplied)

Receiver Operating Parameters:
 Status Supervision: Monitored on each channel for hourly status transmissions, reports status exception if no transmissions received within last 8-hour time period; one common status output provided for all channels; 7-segment display indicates channel where violation occurred; exception set and cleared by channel
 Enable Options: Status supervision enabled per channel; status enabled by cutting proper jumper per channel; factory default disabled; Note: with status supervision monitoring, it is not recommended to have more than one transmitter learned per channel
 Low Battery Supervision: Monitors each transmitter for low battery alarm; reports if any learned transmitter low battery signal received; one common low battery output for all transmitters; 7-segment display indicates channel where low battery occurred; low battery set and cleared by individual transmitters; transmitter that sends low battery report must send a good battery signal to clear low battery condition
 Program Mode: Enabled by program jumper; remove to enter program mode
 Transmitter Learn: Momentary press and release desired channel learn button; activate transmitter with five seconds to learn it into desired channel
 Memory Erase: Hold appropriate channel learn button for more than 10 seconds and release; transmitters learned into that channel will be erased from receiver memory
 Memory Interrogation:
 Hold appropriate channel learn button for more than five and less than 10 seconds; alarm LED will flash the number of transmitters learned into selected channels